lexus is 350 draw tite hitch installation

From the center of our hitch pinhole forward to the bumper, it's about 1/2 inch. From the ground to the inside top edge of the receiver tube opening, we've got about 14-3/4 of an inch. Here are a couple of measurements that might be helpful when selecting your ball mount, bike rack, or even hitch cargo carrier. You definitely want to check out the owner's manual on the RX 350, see what its tow ratings are and then go off of whichever those numbers are the lowest. Now, it's not rated for use with weight distribution, so that's not going to be an option. That's the total weight of our trailer and anything that we we're to load up on it. It's going to give us a 3,500-pound gross trailer weight rating. The hitch itself is going to offer a 350-pound tongue weight rating, so it's the maximum downward force we can put here at our receiver tube opening. I think it's going to offer you the way the hitch comes out a little bit, if you needed it, even a little spot to step there maybe to get up to your roof rack or cargo that you might have on top of your vehicle, and they're plenty of large enough, shouldn't have any issues getting our chains connected. That's the only time you're going to use this rear-most hole.

One of those accessories is the J-pin stabilization system. Want to use class III rated accessories and you can see there's going to be plenty of room there for those. Now, to secure all of your items, you'll want to use this forward-most hole, the one closed to the front of the vehicle. You can see the reinforcement collar here on the end. They've got accessories that are going to fit these class III hitches. That's a Class III rated hitch, which means you're going to have tons of accessories available for it, whether it's going to be ball mounts for towing, bike racks, cargo carriers.

See our receiver tube opening here offers the 2-inch by 2-inch opening. This custom fit design allows for a drop down that's going to go around the exhaust that eliminates the need for us to lower or remove the exhaust to put our hitch up into place. As you can see, we've got our side plates, the crosstube. Here's what our hitch is going to look like installed. Click for more info and reviews of this Draw-Tite Trailer Hitch: Check out some similar Trailer Hitch options: Search for other popular Lexus RX 350 parts and accessories: Don’t forget to subscribe! Full transcript: Today on our 2007 Lexus RX 350, we're going to take a look at and also show you how to install the Draw-Tite Max-Frame Custom Fit Class III Trailer Hitch Receiver, offering the 2-inch by 2-inch opening.

Lexus is 350 draw tite hitch installation